Contact Mode Tip in NC mode.

[Sagar Prasad]

Hi all,

Can I use contact mode tip in non-contact mode. I am using Nanonics MV1000
AFM and I have Budjet sensor's -contact mode tips which on the box mentioned
the resonanat frequency is 13KHz, but when I am using this tip in Noncontact
mode, In Non-Contact tuning I am getting the resonant frequency around
110KHz. Is it Ok to use Contact mode tips in NC mode ?

thanks for your suggestions.
--
regards,
Sagar Prasad Yadavali,
Graduate Research and Teaching Assistant,
Dept.Of.Chemical and Biomolecular Engg,
University of Tennessee,Knoxville.

[Jacqueline Ross]

Hi Sagar,

I think you are addressing your enquiry to the wrong address.

Kind regards,

Jacqui

Jacqueline Ross

Biomedical Imaging Microscopist
Biomedical Imaging Research Unit
School of Medical Sciences
Faculty of Medical & Health Sciences
The University of Auckland
Private Bag 92019
Auckland, NEW ZEALAND

Tel: [phone] Ext 87438
Fax: [phone]

http://www.fmhs.auckland.ac.nz/sms/biru/


-----Original Message-----
From: ImageJ Interest Group [mailto:[hidden email]] On Behalf Of
Sagar Prasad
Sent: Thursday, 23 September 2010 4:26 a.m.
To: [hidden email]
Subject: Contact Mode Tip in NC mode.

Hi all,

Can I use contact mode tip in non-contact mode. I am using Nanonics
MV1000
AFM and I have Budjet sensor's -contact mode tips which on the box
mentioned
the resonanat frequency is 13KHz, but when I am using this tip in
Noncontact
mode, In Non-Contact tuning I am getting the resonant frequency around
110KHz. Is it Ok to use Contact mode tips in NC mode ?

thanks for your suggestions.
--
regards,
Sagar Prasad Yadavali,
Graduate Research and Teaching Assistant,
Dept.Of.Chemical and Biomolecular Engg,
University of Tennessee,Knoxville.