Interactive 3D Surface Plot

[Philip Ershler]

Hello,
        I have been exploring the Interactive 3D Surface Plot plugin. It  
makes beautiful images from my data. What I have however is a stack  
of images (in time). I would like to be able to set up all the  
viewing parameters in Interactive 3D Surface Plot on an initial image  
and then have it run through my stack producing another stack that  
could be saved off as a QuickTime movie.

        Could this be done from a macro? Is there any way to call  
Interactive 3D Surface Plot from a macro with all the pertinent  
parameters? Is there a better way to do this? Any and all suggestions  
gratefully received.

Thanks, Phil

Philip R. Ershler Ph.D.
University of Utah
Cardiovascular Research and Training Institute
95 South 2000 East
Salt Lake City, UT 84112-5000

phone: [phone]
alt ph: [phone]
fax: [phone]
e-mail: [hidden email]

[Morten Bo Mikkelsen]

I'm looking for exactly the same, so I too will appreciate if someone has a solution.

Morten Bo Mikkelsen

Philip Ershler wrote

I would like to be able to set up all the  
viewing parameters in Interactive 3D Surface Plot on an initial image  
and then have it run through my stack producing another stack that  
could be saved off as a QuickTime movie.

Could this be done from a macro? Is there any way to call  
Interactive 3D Surface Plot from a macro with all the pertinent  
parameters? Is there a better way to do this? Any and all suggestions  
gratefully received.