|
|
Dear all,
I'm taking measurements on various particle in an image using the in-built analyse particles command. I display the result table where all the measurements for each particle are stored. Through a macro routine and having the result table displayed, I would like to get some additional measurement for different part of the image and therefore I have to display results in a table, but I need to keep the 1st result table open at the same time as I have to read from it later in my macro.
Is there a way to:
- get two result table at the same time
- read from both result table
I've tried getStatistics, but when you run it, it resets the 1st result table and then all the previous measurements are lost...
Do you have any suggestions to overcome this problem?
Many thanks,
France
|
Locked
